Skip to content
  • Home
  • Products
  • Tuning
  • Servicing
  • International Partners
  • Manuals
  • COVID-19 Update
  • Contact
  • Log in
  • Facebook
  • Instagram
  • YouTube
COVID-19 Update - Open for business. Click here to see our COVID-19 information.
Vorsprung Suspension Vorsprung Suspension Vorsprung Suspension Vorsprung Suspension
  • Home
  • Products
  • Tuning
  • Servicing
  • International Partners
  • Manuals
  • COVID-19 Update
  • Contact
Log in Search Cart
2 comments · Feb 15, 2015

Vorsprung Corset air sleeves - the how and the why

Air springs traditionally haven't been very good. In fact, they've been pretty terrible. Their severe non-linearity has meant that frame designers and riders alike have struggled for decades to achieve spring rates that, at the very least, don't suck. That non-linearity, in the past, has been addressed at the end of the stroke by means of altering the air can's volume using volume-reduction spacers (Fox, Cane Creek and Rockshox all offer kits for this, for their high-end air shocks). This has provided riders and suspension tuners with a way of controlling the end-stroke ramp-up quite precisely, which means you can use all your travel without smashing the bottom out bumper to pieces. Not everything comes well tuned from the factory though, especially if you purchase an aftermarket shock which didn't come in any way set up for your frame, but at least the means to adjust it exists.

However, even the most finely tuned ending-stroke ramp has never solved the real issue with air springs: traction and support are both poor in the middle of the stroke, and they're harsh at the start of the stroke. Compared to coil shocks, the difference has been night and day. People have long assumed that air shocks will always feel bad, compared to coil shocks. With a Corset air sleeve, that no longer needs to be true.

The Corset produces a distinctly improved beginning and mid stroke spring curve over standard Fox spring curves. This is achieved by huge reductions in the initial falling rate inherent in any standard two-chamber (positive and negative spring) air spring system, and the result is measurably improved.

To understand the numbers, consider that a coil spring (which we can all agree feels really nice) is completely linear. Its spring rate is constant throughout the stroke. However, a particular standard Fox air spring curve has a spring rate that drops by more than 90% from the beginning of the stroke to a point about 10mm in. That is to say, the initial spring rate is more than 10 times higher than the mid-stroke spring rate! Obviously, this means that either the beginning spring rate is much too high, or the mid-stroke rate is much too low - in fact, both are the case. That's why your air shock feels stiff to push on initially, and yet isn't supportive through the middle of the stroke. The following graph is numerically accurate, and explains exactly how big the difference is!

The effects of such a falling spring rate are twofold:

1. Bump compliance early in the stroke totally sucks. Any time the wheel leaves the ground, falls into a hole, or for any other reason extends past the sag point, you are now in a region of travel that is unreasonably stiff. This causes poor traction, poor feel, and a lot of harshness.
2. The mid stroke spring rate is too soft to adequately support you. This is what a lot of riders refer to as "wallowing".

By correcting this issue and delivering a much more linear early and mid stroke (with ending stroke ramp still adjustable using volume reducers), the Corset creates a livelier, more controlled, smoother and more predictable ride - much more like a coil spring.

We could tell you it's "exactly the same as a coil", but even though some of our test riders were hard pressed to tell the difference, that wouldn't be quite accurate (as you can see from the above graphs), nor actually desirable - if your bike came with a Fox air shock, your frame is (or should be) designed around the end stroke ramp up of that air shock. Using a 100% linear spring would not provide the bottom-out resistance that an air shock can deliver, which would actually harm performance in many cases. 

After 2 years of development and testing, the Corset represents the highest level of performance currently achievable from your Fox air shock, and is available now for purchase through our web shop!


2 comments


  • Dave Remmey Nov 28, 2018

    Are there any plans to produce the Corset in metric sizes? Esp 210×55 for the Ibis Ripmo.


  • Dustin blada Mar 25, 2017

    I’ve got a 2014 trek remedy 7 and purchased the push volume dampening system they produce for my fox float drcv. I just saw on a forum about the corset. Just curious if I went with the corset would I need to get rid of the volume damper? I ride really rough and trying to fine tune my suspension. Not to mention I live in Arizona where small bump compliance would be sufficient for screaming down a near vertical DH section at speeds around 18mph.


Leave a comment


Back to News

Invalid password
Enter

VORSPRUNG SUSPENSION

#18-1005 Alpha Lake Rd
Whistler, BC
V8E 0H5 

HOURS
Mon - Fri / 8am - 4pm
Sat - Sun / CLOSED

Main Menu

  • Home
  • Products
  • Tuning
  • Servicing
  • International Partners
  • Manuals
  • COVID-19 Update
  • Contact

Sign up and save

Subscribe to get special offers, free giveaways, and once-in-a-lifetime deals.

  • Facebook
  • Instagram
  • YouTube

Powered by Shopify

  • Facebook
  • Instagram
  • YouTube

Powered by Shopify